Apr 23 2011

Engine Interference

Today was full of awwww shits….  now that the wiring is done, it is time to go back to working on the engine.  I need mod the oil cooler ducts and get some oil/fuel hose made up.  Shortly after starting some unforeseen miss matches showed up.

With the top cowl on I dont have enough clearance on the oil dipstick!  Shit the door wont close…

 

I ended up cutting the dip stick down to shorten it 3/4″

I also found the cowl hits on the front of #4 cylinder….shit.  I didnt want to cut up the baffling (dont have the time) or remake the #4 cylinder box, so I just bumped put the cowl.  Did want to do it but I had no choice. 

 

 After cutting the cowl out, I made a foam shape and glassed it in.  

I also needed to make a new duct for the oil cooler since I changed the intlet and outlets.  This is the shape of the old duct.

 

You can see how the tubes no longer match up.

I felt it necessary to come up with a inlet tube which uses NO SCAT tubing, and still allows the easy removal of the lower cowl.

The cooler was encapsulated in foam and then carved it to the right shape.  It is then covered in duct tape (black and red) to get ready for the glassing.  This is the part of fiberglass work I really enjoy because it is very artistic. 

 Better get to glassing!