Mar 17 2011

Panel ready to install

Today the wiring on the instrument panel was finished out. 

Prior to the final install in the plane, I needed to do as much wiring as possible on the bench.  All the harness were hooked up and installed and the point to point wiring on the panel was completed.

What a mess of wires.  The majority of them are just power and grounds.  I decided to route them on the stbd side of the plane as the port side has a huge number of wires and I didnt want to add to the the complexity.

Nicely bound together.  Tomorrow I will do the FINAL installation of the panel in the plane and  “marry” the wiring together.  Once done, this harness will become part of the plane harness.

No Comments

No comments yet.

RSS feed for comments on this post.

Leave a comment